Stator NM 053 SY1

Stator for Netzsch Nemo NM 053 SY1 mono pumps / progressive cavity pumps

Our stators are Made in Germany and available in various colours and materials (elastomers). The standard stator is black on the inside, made of NBR material and has no holes for sensors ("TSE holes"). Zeichnungsposition: 3005 Bitte wählen Sie aus, welche Ausführung Sie benötigen. If you need a special design or are not sure: Simply write a short note in the shopping cart. - Of course, you can also contact our spare parts hotline and we will help you directly. Our recommendation: Order the rotor assembly kit as well. It contains a few small parts that you should replace when you reattach the rotor to the joint. When disassembling, also check the condition of the rotor. Does it have grooves or other indications of wear? Depending on the medium you are pumping (e.g. toothpaste or media with a lot of solids), a rotor can wear out quite quickly. It is best to purchase both from a single source. This will ensure that the rotor and stator are suitably matched to each other! For a complete service, you should also check the joints on the rotor and drive shaft and replace them if necessary. Our tip: You can send us your old joints. We will then check and renovate them for you. In most cases, this is possible with the replacement of some wearing parts. This is good for the environment and easy on your wallet!

Options:

Available elastomers: dark/black = NBR / EPDM / CSM / HNBR / FPM. Light/white elastomers = NBR light, EPDM light, HNBR light, FKM light. Explanation: The elastomer is the rubber mixture inside the stator. They are available in a black mix (B60G, which is the standard) or in light (RAL1015). The light-coloured mixture is used to pump light-coloured lacquers or light-coloured foodstuffs. This prevents the smallest abrasions of the elastomer mixture from changing the colour. Regardless of elastomer colour, all our stators are food grade. TSE drillings. These are prefabricated holes for screwing in temperature sensors. We can also supply the appropriate sensors with the stator. Inlet cone: Our stators are available with a conical inlet cone. This achieves better suction behaviour. Our recommendation: The surcharge is low and the pump sucks better. In some applications, it even reduces the power consumption of your pump.